|
Cabinet and Chassis Restoration and Refinishing For help with cabinet or chassis restoration (non-electrical), please leave a message here. |
|
Thread Tools |
3rd May 2005, 12:13 pm | #1 |
Retired Dormant Member
Join Date: Aug 2003
Location: Stansted Essex
Posts: 263
|
DAC90A Tuning calibration label
Hi all.
Picked up a very cheap 90A a while ago (another one! ) which I am restoring. Has anyone got a scan or a reproduction of the green calibration label which is usually stuck on the back of the dial assembly ?. I wouldn't normally go to this extreme with one of these, but the rest of chassis is in such excellent condition, that it seems a shame not to replace the label. Thanks Pete |
3rd May 2005, 4:31 pm | #2 |
Retired Dormant Member
Join Date: Apr 2003
Location: Blackpool, Lancashire, UK.
Posts: 4,061
|
Re: DAC90A Tuning calibration label
Hi Pete,
If it's of any use to you, I've just scanned the attached image from the actual Bush service sheet. Maybe you can make a new one using this info. |
3rd May 2005, 6:50 pm | #3 |
Tetrode
Join Date: Apr 2005
Location: Holmfirth, West Yorkshire, UK.
Posts: 55
|
Re: DAC90A Tuning calibration label
I am working on a DAC90A at the minute (still doesn't work).
Here are a couple of shots of the label with a ruler in shot. Should enable you to make you're own. Might be easier if the ruler were in inches not millimeters but I am sure there is enough info to be able to make a label. |
3rd May 2005, 7:38 pm | #4 |
Nonode
Join Date: Jun 2004
Location: Norwich, Norfolk, UK.
Posts: 2,543
|
Re: DAC90A Tuning calibration label
Hi
Due to the fact that that I've go nothing better to do , I've re-worked the photo that Cerberos has posted. It's a little difficult to work out the exact dimensions but I have done my best. The finished print needs to be 8.35cm in length HTH David |
4th May 2005, 12:36 pm | #5 |
Retired Dormant Member
Join Date: Aug 2003
Location: Stansted Essex
Posts: 263
|
Re: DAC90A Tuning calibration label
Hi all.
Well what can I say . Many thanks to all, and especially to David for the finished article. Now just to find a suitable backing for the label . Must try to find some clear inkjet labels big enough. Cerberos Good luck with your 90A I hope the chassis is not as rusty as the tuning slide looks,seems you have your hands full there Thanks chaps. Pete |
20th May 2005, 1:07 pm | #6 |
Retired Dormant Member
Join Date: Aug 2003
Location: Stansted Essex
Posts: 263
|
Re: DAC90A Tuning calibration label
Thanks all.
Thanks to the image that David provided, I have now reproduced a fairly acceptable label using the self adhesive clear film I purchased (see my other thread regarding the Hacker Silver Knight). As this label is fairly small the result is quite acceptible, although It would not really be suitable for a much larger decal, the print quality is not very good on this film, I am still trying a number of different print options. Pete |