|
Vintage Amateur and Military Radio Amateur/military receivers and transmitters, morse, and any other related vintage comms equipment. |
|
Thread Tools |
6th Dec 2020, 10:00 pm | #1 |
Diode
Join Date: Dec 2020
Location: Hillsburn, Nova Scotia, Canada.
Posts: 3
|
PYE Mobile Radio Telephone
Cheers from the Other side of the Atlantic. I purchased this set several years ago and have had it in storage, never really paid much attention to it till recently. I noticed it was made in England for the PYE Canada Limited Toronto, Just wanted to know what it was used for; military/public or other.
|
6th Dec 2020, 11:11 pm | #2 |
Heptode
Join Date: Jan 2008
Location: Birchington Kent, UK.
Posts: 596
|
Re: PYE Mobile Radio Telephone
That is a dash-mount Ranger. I used one during the 1970s on 4 metres.
I think a variety of public services used them.
__________________
Regards Pete |
7th Dec 2020, 2:11 am | #3 |
Diode
Join Date: Dec 2020
Location: Hillsburn, Nova Scotia, Canada.
Posts: 3
|
Re: PYE Mobile Radio Telephone
Thank you Pete for that information, I assume it operates on 12VDC?
|
7th Dec 2020, 9:24 am | #4 |
Heptode
Join Date: Mar 2008
Location: Newmarket, Suffolk, UK.
Posts: 612
|
Re: PYE Mobile Radio Telephone
The label says 12v?
You should check if the 12v is positive or negative ground though? It might be floating ground also? Fred G4BWP |
7th Dec 2020, 9:51 am | #5 |
Nonode
Join Date: Jun 2010
Location: Spalding, Peterborough, Cambridgeshire, UK.
Posts: 2,858
|
Re: PYE Mobile Radio Telephone
The set shown is the vibrator psu version. The Transistor Ranger superseded it, with inverter psu.
Fairly certain they were all floating ground. But, around 1970s some mobiles were negative ground only. Eg. The MF6AM Reporter. Rob
__________________
Apprehension creeping like a tube train up your spine - Cymbaline. Film More soundtrack - Pink Floyd |
7th Dec 2020, 11:18 am | #6 |
Heptode
Join Date: Feb 2008
Location: Great Barr, Sandwell, West Midlands, UK.
Posts: 589
|
Re: PYE Mobile Radio Telephone
Over here the dash-mount AM Rangers were designated PTC2002 and PTC2007, dependant on the inverter type. There was also a big (and heavy!) boot-mount version, the PTC2202/2207. At least one local pre-West Midlands fire brigade used the P-band version (79-101MHz) in the 1960s.
More info HERE Good luck getting it running, and enjoy the vintage whine... Martin G4NCE Last edited by Sparky67; 7th Dec 2020 at 11:26 am. |
7th Dec 2020, 2:57 pm | #7 |
Octode
Join Date: Jun 2013
Location: Huddersfield, West Yorkshire, UK.
Posts: 1,795
|
Re: PYE Mobile Radio Telephone
I used the MOD transformer from a Ranger in my first 2M AM transmitter... bought from NW Electrics in Mancs.
__________________
Should get out more. Regards Wendy G8BZY |
7th Dec 2020, 6:26 pm | #8 |
Diode
Join Date: Dec 2020
Location: Hillsburn, Nova Scotia, Canada.
Posts: 3
|
Re: PYE Mobile Radio Telephone
I would like to thank everyone for the information on this unit. I will not be the one to take on the task of restoring to working condition, I am passing it on to another who has more inters in this equipment. My focus is on wooden consoles, table tops and the plastic or wood radios from Europe. I have several European radios that I have picked up over the years, military family's usually brought them back when retuning from overseas.
I will most likely be seeking your knowledge when I start with the Euro sets. Thanks again for your help, very much appreciated. Keith |
7th Dec 2020, 7:46 pm | #9 |
Hexode
Join Date: Feb 2007
Location: Near Lichfield, Staffordshire, UK, most of the time and Crystal Palace, S London, some of the time..
Posts: 330
|
Re: PYE Mobile Radio Telephone
The vibrator PSU Rangers are polarity insensitive, you can wire them either way around, although one lead does go directly to the case. So you can wire one directly to either pos or neg earth. The Transistor Ranger is a different kettle of fish.
I have two sitting on the end of the bench at the moment, with vibrators that do not want to play. Good luck. Ian |