UK Vintage Radio Repair and Restoration Powered By Google Custom Search Vintage Radio Service Data

Go Back   UK Vintage Radio Repair and Restoration Discussion Forum > General Vintage Technology > Hints, Tips and Solutions (Do NOT post requests for help here)

Notices

Hints, Tips and Solutions (Do NOT post requests for help here) If you have any useful general hints and tips for vintage technology repair and restoration, please share them here. PLEASE DO NOT POST REQUESTS FOR HELP HERE!

Closed Thread
 
Thread Tools
Old 21st Aug 2010, 10:10 am   #1
awc
Hexode
 
awc's Avatar
 
Join Date: Jul 2005
Location: Somerset, UK.
Posts: 334
Default Curing unwanted oscillation

As you may have seen from the Vintage Radio (domestic) section, I sought help in curing a severe case of unwanted oscillation in my recently restored Pye QAC2.

The problem was helped by wrapping copper wire around the bottom of V2 (Every Ready A50P) but the oscillation was still bad. I prodded and poked about in the wiring and this did reduce the problem but did not remove it.

On turning the chassis right way up and approaching the top cap grid of the output bottle (Pen4DD) the oscillation was reduced further and by grasping the lead to the top cap, further still. The set now worked ok at lower volumes but came on again as the volume control was advanced.

As the top cap lead wasn't screened, I replaced it with a bit of audio co-axial which as it's black doesn't look much out of place. This was earthed only at the chassis end. This cured the problem completely and the set now performs fautlessly.

Worth giving a go if your set exhibits similar problems
awc is offline  
Old 21st Aug 2010, 3:01 pm   #2
merlinmaxwell
Dekatron
 
merlinmaxwell's Avatar
 
Join Date: Jul 2008
Location: Maidenhead, Berkshire, UK.
Posts: 9,488
Default Re: Curing unwanted oscillation

Nice detective work, some grid top sockets also have a stopper resistor of a few k there to stop parasitic oscillations.
__________________
Cats have staff, it's dogs that have owners.
merlinmaxwell is online now  
Old 22nd Aug 2010, 5:21 pm   #3
ColinB
Heptode
 
ColinB's Avatar
 
Join Date: Apr 2003
Location: Newton Abbot, Devon, UK.
Posts: 610
Default Re: Curing unwanted oscillation

Yes, it could make good sense. I'll try it with a set I've got here with this problem.
ColinB is offline  
Closed Thread

Thread Tools



All times are GMT +1. The time now is 12:52 pm.


All information and advice on this forum is subject to the WARNING AND DISCLAIMER located at https://www.vintage-radio.net/rules.html.
Failure to heed this warning may result in death or serious injury to yourself and/or others.


Powered by vBulletin®
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Copyright ©2002 - 2020, Paul Stenning.