|
Homebrew Equipment A place to show, design and discuss the weird and wonderful electronic creations from the hands of individual members. |
|
Thread Tools |
15th Apr 2017, 12:06 pm | #1 |
Heptode
Join Date: Mar 2016
Location: Essex, UK.
Posts: 602
|
D.C. Volt Meter
Forgot I made this quite a while ago from a Radio Constructor project (March 1972), powered it up with two PP3's and it still works and is accurate enough to test circuits. It uses the LM709 Op Amp and has a 10x gain with 100K Ohms input impedance. I only fitted resistors for ranges from 100mV to 10Volts as I couldn't afford the larger value resistors at the time for the 30, 50, and 100Volt ranges. I laid it out differently to the original Radio Constructor design with the controls such as Set Zero and meter 'Off protect' switch combined with the on/off switch at the front. The meter only has rough pen markings on but is good enough for home use. The front panel was sprayed with Hammerite and clear varnish that has lasted quite well.
__________________
Geoff Last edited by GeoffK; 15th Apr 2017 at 12:23 pm. |
15th Apr 2017, 9:09 pm | #2 |
Heptode
Join Date: Dec 2014
Location: Lincoln, Lincolnshire, UK.
Posts: 583
|
Re: D.C. Volt Meter
Nicely constructed
|
15th Apr 2017, 10:05 pm | #3 |
Hexode
Join Date: Jun 2005
Location: Aberystwyth, Wales, UK.
Posts: 358
|
Re: D.C. Volt Meter
Nicely made, I always like to see homemade test equipment.
Dave GW7ONS |
15th Apr 2017, 11:38 pm | #4 |
Dekatron
Join Date: Jul 2008
Location: Charmouth, Dorset, UK.
Posts: 3,601
|
Re: D.C. Volt Meter
Very neat, somewhat above my standard of construction.
Peter |
16th Apr 2017, 10:15 am | #5 |
Heptode
Join Date: Mar 2016
Location: Essex, UK.
Posts: 602
|
Re: D.C. Volt Meter
Thanks for all your comments, it seemed more fun back then to buy components from places like Home Radio and Henrys without to much regard of it being uneconomic to make. The yellow switch wiring is a bit untidy as I thought I might get round to fitting the remaining resistors.
__________________
Geoff |
17th Apr 2017, 6:22 pm | #6 |
Dekatron
Join Date: Jun 2016
Location: London, UK.
Posts: 3,687
|
Re: D.C. Volt Meter
I like the hammer finish. I come from a family that applied Hammerite to literally everything so I have fond memories
Good point with the economics of building versus buying stuff. I recently built a FET voltmeter myself. Yes you can get a perfectly good DMM for £2.68 on CPC and my "main" Fluke, an 8021B, cost me £21. I must have spent twice that building a technically inferior voltmeter. However, I learned a lot more building something than buying and enjoyed the process immensely and that is priceless. It's still more fun to build versus buy. |
18th Apr 2017, 9:42 am | #7 |
Heptode
Join Date: Mar 2016
Location: Essex, UK.
Posts: 602
|
Re: D.C. Volt Meter
This is the circuit of the D.C. Voltmeter. I agree about the Hammerite it is a very good paint.
__________________
Geoff |