UK Vintage Radio Repair and Restoration Powered By Google Custom Search Vintage Radio and TV Service Data

Go Back   UK Vintage Radio Repair and Restoration Discussion Forum > General Vintage Technology > Where To Get Sets and Parts


Where To Get Sets and Parts For discussions about swapmeets, rallies, NVCF and BVWS, car boot sales, antique and charity shops, dealers, newspaper adverts, the local tip and just about any other source of equipment (other than eBay).

Thread Tools
Old Yesterday, 9:31 pm   #61
greenstar's Avatar
Join Date: Jul 2011
Location: Leicester, Leics. UK.
Posts: 1,378
Default Re: Seeking a Cornish Dealer from the past

Hi Peter, I believe the radio licence covered it pre-war, but there was a TV licence in 1946, presumably when TV broadcasting started again. I'm not sure what information is available, but if anything is, it could be cross referenced, say with a surname and area? I would think your set would have been in use post war, as a TV was still a rare thing in the 50's where i came from!
greenstar is offline   Reply With Quote
Old Yesterday, 11:20 pm   #62
peter_scott's Avatar
Join Date: May 2003
Location: Edinburgh, UK.
Posts: 2,666
Default Re: Seeking a Cornish Dealer from the past

Thanks Tony,

Unfortunately I haven't been able to identify Michael Scott's father (if he was the London area owner) and Scott is just too common a name. Searching Ancestry I can find quite a few Michael Scotts in Cornwall of about the right age but I couldn't find a father who had lived in London.

If my wife's memory of Michael Scott receiving the set from his father is a myth then the other possible London owner might be the gentleman who Mike remembers as having sold a similar set in the late 1970s to a dealer in Redruth (Mr Delves). Although Mr Delves is dead, Lawrence suggested a Facebook route to make contact with the Delves family. Whilst I have made contact with his daughter and she will contact other family members this route has also drawn a blank so far.

peter_scott is offline   Reply With Quote

Thread Tools

All times are GMT. The time now is 2:06 am.

All information and advice on this forum is subject to the WARNING AND DISCLAIMER located at
Failure to heed this warning may result in death or serious injury to yourself and/or others.

Powered by vBulletin®
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
Copyright ©2002 - 2021, Paul Stenning.