|
Cabinet and Chassis Restoration and Refinishing For help with cabinet or chassis restoration (non-electrical), please leave a message here. |
|
Thread Tools |
15th May 2020, 8:58 pm | #1 |
Heptode
Join Date: Oct 2008
Location: Aalborg, Denmark
Posts: 903
|
EM84 Mounting Bezel
Hi,
Has anyone here done a 3D-print of a mounting Bezel for an EM84 (or other) magic eye valve ? Originally they were done in bakelite, plastic or even brass and the valve was usually fixed against the rear of the Bezel with a coiled spring wrapped around the valve. Cheap 3D-printing would of course be done in plastic but metal-printing is also a choice if you can afford it, se the attached picture. This Bezel was even gilded in 9ct. gold. (Picture taken from the Internet) Rgds, /Torben |