UK Vintage Radio Repair and Restoration Powered By Google Custom Search Vintage Radio Service Data

Go Back   UK Vintage Radio Repair and Restoration Discussion Forum > General Vintage Technology > Success Stories

Notices

Success Stories If you have successfully repaired or restored a piece of equipment, why not write up what you did and post details here. Particularly if it was interesting, unusual or challenging. PLEASE DO NOT POST REQUESTS FOR HELP HERE!

Reply
 
Thread Tools
Old 31st Dec 2018, 5:36 pm   #1
Beardyman
Pentode
 
Beardyman's Avatar
 
Join Date: Jan 2018
Location: Portsmouth, Hampshire, UK.
Posts: 116
Default PYE 47X (AKA Invicta 200B)

I felt I needed something to keep me "out of trouble" over the Christmas break so I purchased a little PYE47X bakelite radio that appeared in a local charity shop for the princely sum of 7.50. It looked a wee bit sad for itself but the case was (under all the grime) intact. The plastic window had become loose & was almost opaque, oddly yellow but that was our old friend cigarette smoke/kitchen fumes. It had obviously been repaired at some point in the past but a long time ago. All the waxy's over 0.1uF were leaky/blown up. Most of the resistors were way out of their 20% tolerance as well, oddly there were two 1M's that were 'intermittent', out of circuit they would measure about 1M but if their leads were stressed this figure would drop to about 200K! Most odd. The valve line up was standard apart from the output valve, this was supposed to be a 35L6GT, in this one there was a 50L6GT, same valve but different filament voltage. After the usual clearing out of the accumulated dust/dirt/spider remains & cobwebs it was looking fairly ok. This set differs from most in that it uses inductive tuning & reflex IF rather than capacitive to receive different stations, quite a novelty in some ways. After application of switch cleaner to the volume pot & wave change switch it was time to apply some power. This, for me at least, is always a nerve wracking moment! It doesn't seem to matter how many times I check I ALWAYS check again, just to make sure. As this is an AC/DC set I decided to use the lamp limiter, all appeared well initially. After about 30 seconds or so there was a feint sign of noise from the speaker, with an aerial attached it successfully pulled in a few local MW stations. Then I notices smoke! Heck! Where was that coming from? And why did it smell of talcum powder?!? It was, of course, the dropper burning off years of accumulated dust & moisture. Over several cooling/heating cycles this has now stopped but that dropper gets mighty hot. As to where the set will go now I have no idea, no doubt a place will show itself, eventually.........
Attached Thumbnails
Click image for larger version

Name:	DSC_0206.jpg
Views:	98
Size:	73.1 KB
ID:	175500   Click image for larger version

Name:	DSC_0209.jpg
Views:	99
Size:	89.3 KB
ID:	175501   Click image for larger version

Name:	DSC_0240.jpg
Views:	92
Size:	80.4 KB
ID:	175502   Click image for larger version

Name:	DSC_0243.jpg
Views:	101
Size:	97.6 KB
ID:	175503   Click image for larger version

Name:	DSC_0244.jpg
Views:	91
Size:	72.5 KB
ID:	175504  

__________________
The difference between stupidity and genius is that genius has its limits. (Einstein)
Beardyman is offline   Reply With Quote
Old 1st Jan 2019, 3:28 pm   #2
Wellington
Pentode
 
Wellington's Avatar
 
Join Date: Jun 2009
Location: Cheshire, UK.
Posts: 231
Thumbs up Re: PYE 47X (AKA Invicta 200B)

That's a nice find! I've never seen one of those before, and I like the look of it.

What did you do about the output valve did you have a spare 35L6GT?
Wellington is offline   Reply With Quote
Old 1st Jan 2019, 3:44 pm   #3
Beardyman
Pentode
 
Beardyman's Avatar
 
Join Date: Jan 2018
Location: Portsmouth, Hampshire, UK.
Posts: 116
Default Re: PYE 47X (AKA Invicta 200B)

I thought as it was a higher voltage it wouldn't do any harm to fire it up as was. Even though the heater chain required an extra 15 volts it seems to work ok. I may well return to it at some point but I have another set on the go, this will be a long term one as there is little to no information about it on this forum or on Paul's excellent DVD-ROM. It does have a certain charm to it, even though it was probably in the "cheap & cheerful" end of the radio market at the time. Dates found inside were from September 1947, I realise that is just an indicator rather than an absolute time but it's done well to survive this long, obviously cared for over the years.
__________________
The difference between stupidity and genius is that genius has its limits. (Einstein)
Beardyman is offline   Reply With Quote
Reply

Thread Tools



All times are GMT +1. The time now is 5:18 am.


All information and advice on this forum is subject to the WARNING AND DISCLAIMER located at https://www.vintage-radio.net/rules.html.
Failure to heed this warning may result in death or serious injury to yourself and/or others.


Powered by vBulletin®
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright ©2002 - 2018, Paul Stenning.