|
General Vintage Technology Discussions For general discussions about vintage radio and other vintage electronics etc. |
|
Thread Tools |
28th Jan 2011, 1:47 pm | #1 |
Retired Dormant Member
Join Date: Jan 2011
Location: Thessaloniki, Greece.
Posts: 1
|
KRAFT series seventy two 6CH RC Transmitter
Dear Friends
Recently a friend of mine gave me the above mentioned RC transmitter for alignment after tampering with it's insides. He says it was working OK before he decide to install a new 3s (11,1V) LiPo battery pack. I checked output power and frequency and they are OK but as I found out he did rotate the pulse width adjustment resistor pots (7 of them). So now I have to realign them in order for the associated receiver to be able to output the correct servo channels. I do not have a service manual or circuit diagram.The PCB is has transistor multivibrator for creating the 20ms frame and subsequent pulse delay sections(contolled by the pots). I slightly adjusted back and forth some of the pots but with no luck. Anyone having any info that I can use? Bill |