|
Vintage Test Gear and Workshop Equipment For discussions about vintage test gear and workshop equipment such as coil winders. |
|
Thread Tools |
19th May 2008, 10:52 pm | #1 |
Dekatron
Join Date: Apr 2005
Location: Bewdley, Worcestershire, UK.
Posts: 4,748
|
Taylor model 110B capacity/resistance bridge
Does anyone have a circuit diagram or manual for this instrument, please? I have just acquired one which works OK on the resistance ranges, but not on capacitance. Any assistance will be welcome.
Thank you,
__________________
Phil Optimist [n]: One who is not in possession of the full facts |
19th May 2008, 11:28 pm | #2 |
Heptode
Join Date: Jun 2004
Location: Ilkley, West Yorkshire, UK.
Posts: 656
|
Re: Taylor model 110B capacity/resistance bridge
I have an instruction manual and circuit diagram (drawn by Mike Phelan I think) for the 110C if they're of any use to you. PM me with your email address and I'll send them to you.
rgds Colin
__________________
Colin Armstrong |
20th May 2008, 7:56 am | #3 |
Dekatron
Join Date: Nov 2003
Location: Near Leeds, West Yorkshire, UK
Posts: 4,609
|
Re: Taylor model 110B capacity/resistance bridge
It was me, Colin. The PDF of the circuit is over 2mb, even if you ZIP it. If yours is earlier than 06/07/2007 (I did tidy it up at some point) I'll send it to you and Phil.
__________________
Mike. |
20th May 2008, 1:57 pm | #4 |
Dekatron
Join Date: Apr 2005
Location: Bewdley, Worcestershire, UK.
Posts: 4,748
|
Re: Taylor model 110B capacity/resistance bridge
Colin, Mike, thank you very much. I'll PM.
__________________
Phil Optimist [n]: One who is not in possession of the full facts |
23rd May 2008, 12:19 pm | #5 |
Dekatron
Join Date: Apr 2005
Location: Bewdley, Worcestershire, UK.
Posts: 4,748
|
Re: Taylor model 110B capacity/resistance bridge
Thanks to the kind assistance of Mike and Colin, I have now received the information sought. Many thanks to both!
Phil
__________________
Phil Optimist [n]: One who is not in possession of the full facts |