|
Vintage Test Gear and Workshop Equipment For discussions about vintage test gear and workshop equipment such as coil winders. |
|
Thread Tools |
14th Jan 2019, 5:59 pm | #21 |
Pentode
Join Date: Oct 2016
Location: Dover, Kent, UK.
Posts: 237
|
Re: Red and black end caps and others parts....Final solution??
I see they have been modelled in Solidworks. I have used Solidworks to model the very same caps a few years back, and had them 3D printed. The luxury of technology!
I also have the advantage of holding the original part drawings for the entire instrument! Still slowly modelling the entire prodcut for my documentation. |
14th Jan 2019, 10:18 pm | #22 |
Guest
Posts: n/a
|
Re: Red and black end caps and others parts....Final solution??
The STL file for the black and red cap are ready and available for everybody here...
https://www.vintage-radio.net/forum/...61#post1110861 Please tell me if there are any problem with them. |
14th Jan 2019, 11:48 pm | #23 |
Pentode
Join Date: Dec 2018
Location: County Meath, Ireland
Posts: 242
|
Re: Red and black end caps and others parts....Final solution??
Cheers Aitor,
In good spirit I have also uploaded my versions plus the Ohms Adjust knob to your thread. Regards Ray |
18th Jan 2019, 12:11 am | #24 | |
Guest
Posts: n/a
|
Re: Red and black end caps and others parts....Final solution??
Quote:
I read that Megger has the intention to collect Avos and documents for a Museum and you are involved in the project. Can you tell anything about this? Thanks, Aitor Eneko |
|