![]() |
![]() |
![]() |
|
Vintage Tape (Audio), Cassette, Wire and Magnetic Disc Recorders and Players Open-reel tape recorders, cassette recorders, 8-track players etc. |
![]() |
|
Thread Tools |
![]() |
#1 |
Hexode
Join Date: Jun 2014
Location: Chelmsford, Essex, UK
Posts: 386
|
![]()
Hi all, yet another problem with my A77 rebuild. One step forward
![]() ![]() On the switch board (This is the mother board that all the audio cards plug into, No.1.077.435) there is a horizontal trimmer which controls the crosstalk setting between channels. Mine has disintegrated and I am struggling to find a replacement. It is called a Ruwido S 76 K 250K-20%-0.15W. It appears to be a horizontal trimmer that is adjusted through the board it's mounted on. Can anyone suggest where I can get a replacement please? I've looked on Cricklewood's site and Digitec's site but cannot find anything remotely like it. I would be very grateful for some guidance here. Right now I feel like Sylvester, just about to jump on Tweedy Pie and the ******* flown away again!! ![]()
__________________
Small Scotch, New Aids and Happy Ears |
![]() |
![]() |
#2 |
Pentode
Join Date: Feb 2010
Location: Leeds, West Yorkshire, UK.
Posts: 102
|
![]()
I've just been buying a load of side adjusters from this lot....here is the selection that they're offering :
https://www.ebay.co.uk/itm/224103117...IAAOSwOsZfg1hG Scroll down the list...! Kev Last edited by tonewheelkev; 12th Jun 2022 at 5:30 pm. |
![]() |
![]() |
#3 |
Pentode
Join Date: Feb 2010
Location: Leeds, West Yorkshire, UK.
Posts: 102
|
![]()
Previous post has the P15 size.....here's the P10 size too.
B77 has both P10 and P15 sizes! https://www.ebay.co.uk/itm/363180586...oAAOSwAmBfsQEC If P10 is your size....pack of 2 here for almost nowt https://www.ebay.co.uk/itm/112749408...YAAOSwoddaV6li .....I'll stop going on now!!! ![]() |
![]() |
![]() |
#4 |
Hexode
Join Date: Jun 2014
Location: Chelmsford, Essex, UK
Posts: 386
|
![]()
Great, thank you, you keep goin on . . . would you know if they can be adjusted from the back? I will have a scroll through and ask the vendor.
Thanks again.
__________________
Small Scotch, New Aids and Happy Ears |
![]() |
![]() |
#5 |
Pentode
Join Date: Feb 2010
Location: Leeds, West Yorkshire, UK.
Posts: 102
|
![]()
Couldn't resist.....this board looks like it has had a Piher trim fitted....
https://www.ricardo.ch/fr/a/carte-me...29-1195383842/ ....OUT!!!!!!! |
![]() |
![]() |
#6 |
Hexode
Join Date: Jun 2014
Location: Chelmsford, Essex, UK
Posts: 386
|
![]()
HaHa!
![]() Yes, that's the kiddy. In reality it's not difficult to adjust from the back (I think). Thanks for the information. It's appreciated. ![]()
__________________
Small Scotch, New Aids and Happy Ears |
![]() |
![]() |
#7 |
Pentode
Join Date: Feb 2010
Location: Leeds, West Yorkshire, UK.
Posts: 102
|
![]()
BTW....it's MisterKevster....on Tapeheads!!
![]() |
![]() |
![]() |
#8 |
Hexode
Join Date: Jun 2014
Location: Chelmsford, Essex, UK
Posts: 386
|
![]()
Finally, it’s finished! At one point I though it was not going to happen but in the end with a ready supply of components it came through and in all modesty, I’m extremely pleased with it. I now have a genuine ‘standard’ speed half track A77. Completely refurbished with new heads, capstan motor, capacitors, trimmers plus the odd resistor where the originals weren’t quite to spec. Well worth the effort (and occasional frustration).
Thank you all for your recommendations, advice and just plain assistance. It was very much appreciated. (The knee replacement went well too ).
__________________
Small Scotch, New Aids and Happy Ears |
![]() |