UK Vintage Radio Repair and Restoration Powered By Google Custom Search Vintage Radio Service Data

Go Back   UK Vintage Radio Repair and Restoration Discussion Forum > Other Discussions > Homebrew Equipment

Notices

Homebrew Equipment A place to show, design and discuss the weird and wonderful electronic creations from the hands of individual members.

Reply
 
Thread Tools
Old Yesterday, 11:56 pm   #21
Terry_VK5TM
Octode
 
Join Date: Oct 2010
Location: Tintinara, South Australia, Australia
Posts: 1,006
Default Re: PCB Artwork transfer

Even the CNC used to break them Wendy (especially if you set the z axis speed too high ) and because it doesn't have the auto stop feature, was a real pain to get it back to the point where it broke.

If I only had one or two small ones to do, I had a Dremel in a similar stand to yours but that was worse than using an ordinary drill press for breaking drill bits.
__________________
Terry VK5TM
https://www.vk5tm.com/
Terry_VK5TM is offline   Reply With Quote
Old Today, 12:06 am   #22
Wendymott
Heptode
 
Wendymott's Avatar
 
Join Date: Jun 2013
Location: Huddersfield, West Yorkshire, UK.
Posts: 994
Default Re: PCB Artwork transfer

Hi Terry...I used to break the drills fairly regularly till I re adjusted the slide adjustments and since then.. have been fairly lucky with non breakages.
__________________
Should get out more.

Regards
Wendy G8BZY
Wendymott is offline   Reply With Quote
Reply

Thread Tools



All times are GMT +1. The time now is 9:17 am.


All information and advice on this forum is subject to the WARNING AND DISCLAIMER located at https://www.vintage-radio.net/rules.html.
Failure to heed this warning may result in death or serious injury to yourself and/or others.


Powered by vBulletin®
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright ©2002 - 2019, Paul Stenning.