UK Vintage Radio Repair and Restoration Powered By Google Custom Search Vintage Radio Service Data

Go Back   UK Vintage Radio Repair and Restoration Discussion Forum > General Vintage Technology > Hints, Tips and Solutions (Do NOT post requests for help here)

Notices

Hints, Tips and Solutions (Do NOT post requests for help here) If you have any useful general hints and tips for vintage technology repair and restoration, please share them here. PLEASE DO NOT POST REQUESTS FOR HELP HERE!

Reply
 
Thread Tools
Old 4th Dec 2019, 12:55 am   #41
The Philpott
Octode
 
Join Date: Aug 2016
Location: Colchester, Essex, UK.
Posts: 1,949
Default Re: Neon Tester Screwdrivers

I am slightly puzzled that i haven't ever seen any upgrades to the basic Neon Tester design. I was browsing on an IET forum earlier and saw that several bods had had similar thoughts, viz:

-Two (or perhaps even three) resistors of equal value in series, mitigating the effect of a resistor failing s/c (a rather unlikely failure)
This would make the tool bulkier, but it could still be acceptably small- especially compared to a voltpen.

- All the internal components potted in clear resin to exclude (as much as possible) accidental water ingress. Would this increase the energy of the shrapnel in the event of a explosive failure of the tester though..? Heading away from electrics towards ballistics here.

I can't really accept that the proliferation of 'better' testers would have halted development to the point where no-one took the opportunity to develop and improve.
....Or are there hidden consequences to the improvements i have suggested?

Dave
The Philpott is offline   Reply With Quote
Old 7th Dec 2019, 5:01 am   #42
Maarten
Nonode
 
Join Date: Dec 2007
Location: Haarlem, Netherlands
Posts: 2,653
Default Re: Neon Tester Screwdrivers

I think I've seen 2 resistors in series. I think they also use resistors that aren't likely to short or go low.
Maarten is offline   Reply With Quote
Old 7th Dec 2019, 10:33 am   #43
raditechman
Heptode
 
raditechman's Avatar
 
Join Date: Feb 2007
Location: West London, UK.
Posts: 661
Default Re: Neon Tester Screwdrivers

Vintage Engr mentioned
Quote:
BBC-2 colour test film, circa 1967/8
The film with Switch off Isolate Dump and Earth is called "On the Safe Side" It is available on YouTube.
John
raditechman is offline   Reply With Quote
Old 7th Dec 2019, 3:15 pm   #44
vidjoman
Nonode
 
Join Date: Jun 2013
Location: East Sussex, UK.
Posts: 2,231
Default Re: Neon Tester Screwdrivers

Back in the late 1950’s I had a neon tester that had the screwdriver blade cut short and put the rest into a plastic tube, I think resistors came in the tubes, and it was therefore isolated. Used as a guide to tell if line output transformers were working. Only needed to get it within about 2-3 inches and it glowed without having to touch anything.
vidjoman is offline   Reply With Quote
Reply

Thread Tools



All times are GMT +1. The time now is 8:59 am.


All information and advice on this forum is subject to the WARNING AND DISCLAIMER located at https://www.vintage-radio.net/rules.html.
Failure to heed this warning may result in death or serious injury to yourself and/or others.


Powered by vBulletin®
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright ©2002 - 2019, Paul Stenning.