UK Vintage Radio Repair and Restoration Powered By Google Custom Search Vintage Radio Service Data

Go Back   UK Vintage Radio Repair and Restoration Discussion Forum > Specific Vintage Equipment > Vintage Test Gear and Workshop Equipment

Notices

Vintage Test Gear and Workshop Equipment For discussions about vintage test gear and workshop equipment such as coil winders.

Reply
 
Thread Tools
Old 17th Feb 2018, 4:07 pm   #1
bill knox
Pentode
 
Join Date: Mar 2011
Location: Wilstead, Bedfordshire, UK.
Posts: 100
Default Advance TP2B termination

Hi

Would anyone either have an ADVANCE TP2B termination lead or a diagram so that I can build one

All expenses reimbursed

Many thanks
bill knox is offline   Reply With Quote
Old 17th Feb 2018, 4:37 pm   #2
Alistair D
Octode
 
Alistair D's Avatar
 
Join Date: Jan 2010
Location: Edinburgh, UK.
Posts: 1,508
Default Re: Advance TP2B termination

I have information on the TP1B. Not sure how much the TP2 differs.

Al
__________________
I won't tell you how I discovered that.
Alistair D is offline   Reply With Quote
Old 17th Feb 2018, 5:25 pm   #3
bill knox
Pentode
 
Join Date: Mar 2011
Location: Wilstead, Bedfordshire, UK.
Posts: 100
Default Re: Advance TP2B termination

The TP2B in the termination lead used in conjunction with an Advance Sg-62 sig Generator, I am not sure what the difference between the TP1B and the TP2B is

If my memory serves me right, the lead was approx. 2ft long with a 2.5" long by 1.5" wide and about 1" deep with provision for banana plugs, I am hoping to possibly make one using some better RF connectors instead of the banana plugs.

Is your information suitable for an email

Regards

Bill
bill knox is offline   Reply With Quote
Old 17th Feb 2018, 5:44 pm   #4
Alistair D
Octode
 
Alistair D's Avatar
 
Join Date: Jan 2010
Location: Edinburgh, UK.
Posts: 1,508
Default Re: Advance TP2B termination

The only thing I can think of is that the TP1B is 75R. Perhaps the TP2B is for 50R termination. Incidentally the B is for Belling Lee sockets. The original TP1 had a different connector.

PM me an email address, I will send what I have.

Al
__________________
I won't tell you how I discovered that.
Alistair D is offline   Reply With Quote
Old 17th Feb 2018, 9:04 pm   #5
bill knox
Pentode
 
Join Date: Mar 2011
Location: Wilstead, Bedfordshire, UK.
Posts: 100
Default Re: Advance TP2B termination

Hi

As you had mentioned a TP1B, I googled it, and it up with a circuit of the unit, it looks like the one that I used to use 30 odd years ago, it's 75 ohms so I will find a small box and make one up, I still feel that my one had a lead on the end but I could be wrong.

Thanks for the reply and your time

Regards

Bill
bill knox is offline   Reply With Quote
Reply

Thread Tools



All times are GMT +1. The time now is 3:38 am.


All information and advice on this forum is subject to the WARNING AND DISCLAIMER located at https://www.vintage-radio.net/rules.html.
Failure to heed this warning may result in death or serious injury to yourself and/or others.


Powered by vBulletin®
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Copyright ©2002 - 2018, Paul Stenning.