UK Vintage Radio Repair and Restoration Powered By Google Custom Search Vintage Radio Service Data

Go Back   UK Vintage Radio Repair and Restoration Discussion Forum > General Vintage Technology > Where To Get Sets and Parts

Notices

Where To Get Sets and Parts For discussions about swapmeets, rallies, NVCF and BVWS, car boot sales, antique and charity shops, dealers, newspaper adverts, the local tip and just about any other source of equipment (other than eBay).

Reply
 
Thread Tools
Old 31st Jan 2020, 9:02 pm   #1
TowerRadio
Pentode
 
Join Date: Mar 2008
Location: Bristol, UK.
Posts: 156
Default IKEA chassis cutter 6.00

Seen in IKEA "Fixa" set-small pipe cutter and Q-Max type chassis cutter for 35mm hole(presumably to cut hole in stainless steel sink unit) pipe cutter 16mm max 6.00 should cut ali ok.Les
TowerRadio is offline   Reply With Quote
Reply

Thread Tools



All times are GMT +1. The time now is 5:12 am.


All information and advice on this forum is subject to the WARNING AND DISCLAIMER located at https://www.vintage-radio.net/rules.html.
Failure to heed this warning may result in death or serious injury to yourself and/or others.


Powered by vBulletin®
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Copyright ©2002 - 2020, Paul Stenning.