UK Vintage Radio Repair and Restoration Powered By Google Custom Search Vintage Radio Service Data

Go Back   UK Vintage Radio Repair and Restoration Discussion Forum > General Vintage Technology > Where To Get Sets and Parts


Where To Get Sets and Parts For discussions about swapmeets, rallies, NVCF and BVWS, car boot sales, antique and charity shops, dealers, newspaper adverts, the local tip and just about any other source of equipment (other than eBay).

Closed Thread
Thread Tools
Old 31st Jan 2020, 9:02 pm   #1
Join Date: Mar 2008
Location: Bristol, UK.
Posts: 171
Default IKEA chassis cutter 6.00

Seen in IKEA "Fixa" set-small pipe cutter and Q-Max type chassis cutter for 35mm hole(presumably to cut hole in stainless steel sink unit) pipe cutter 16mm max 6.00 should cut ali ok.Les
TowerRadio is offline  
Closed Thread

Thread Tools

All times are GMT +1. The time now is 12:27 am.

All information and advice on this forum is subject to the WARNING AND DISCLAIMER located at
Failure to heed this warning may result in death or serious injury to yourself and/or others.

Powered by vBulletin®
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Copyright ©2002 - 2020, Paul Stenning.