|
Vintage Test Gear and Workshop Equipment For discussions about vintage test gear and workshop equipment such as coil winders. |
|
Thread Tools |
3rd Sep 2017, 4:52 pm | #1 |
Retired Dormant Member
Join Date: Jun 2005
Location: Maesteg, Bridgend County Borough, Wales.
Posts: 26
|
AVO model 72
Hi guys. I have bought an avo model 72 in real good condition. It would appear that the only fault I can see that there is something wrong with the lowest ohms range. For example when you short the probes out it reads zero, correct. However, if you put a low values resistor across it WG , 20 ohm, 75 ohm , 150 ohm it still reads zero. I have the circuit here but with the switches having difficulty in following on the screen. Any experts out there. Have had it apart and the high value , close tolerance resistors, three of them read correctly.
Regards Rog GW3XJC |