|
Vintage Amateur and Military Radio Amateur/military receivers and transmitters, morse, and any other related vintage comms equipment. |
|
Thread Tools |
5th Nov 2017, 9:38 pm | #21 |
Dekatron
Join Date: Apr 2005
Location: Bewdley, Worcestershire, UK.
Posts: 4,748
|
Re: Never assume anything!
Once I was coming to the end of a long restoration job on a 1939 Ever Ready all-dry battery portable. I'd duly identified the four battery connections with labels showing "HT" and "LT" and was preparing to make the connections and switch on.
Then I got interrupted. When the interruption was over, I realised I was running short on time. Red was HT positive, I assumed. You can guess the rest. There was a brief bright flash from all four valves, followed immediately by a sickening feeling and some muttered profanity. That cost me around £25 for a set of scarce valves. So in addition to not assuming anything, I'd advise avoiding interruptions!
__________________
Phil Optimist [n]: One who is not in possession of the full facts |
5th Nov 2017, 10:46 pm | #22 |
Banned
Join Date: Dec 2013
Location: Middlewich, Cheshire, UK. & Winter in the Philippines.
Posts: 3,897
|
Re: Never assume anything!
Ouch I don't do many battery valve sets. I have a habit of wiring 2 silicon diodes in series to ground on the LT positive and a fuse wire in series. Then if the HT gets connected, hopefully the filaments may survive.
|
5th Nov 2017, 11:01 pm | #23 |
Dekatron
Join Date: Apr 2005
Location: Bewdley, Worcestershire, UK.
Posts: 4,748
|
Re: Never assume anything!
I believe that's the crowbar variant of the circuit known as an "idiot diode", Sam. A good tip, and one that this particular idiot should remember!
__________________
Phil Optimist [n]: One who is not in possession of the full facts |
30th Nov 2017, 4:35 am | #24 |
Heptode
Join Date: Oct 2005
Location: Olympia, Washington, USA.
Posts: 664
|
Re: Never assume anything!
Decades ago, HeathKit earned the nick name "GriefKit" here in the States.
Some of their kits had mis-marked resistor color code stripes, and some of the diodes had the cathode band marked on the anode. Made for interesting times, I tell you. Soured me on their products, too. |
30th Nov 2017, 8:20 am | #25 |
Dekatron
Join Date: Apr 2005
Location: Bewdley, Worcestershire, UK.
Posts: 4,748
|
Re: Never assume anything!
That's sabotage! On a serious note, though, I have been caught out by mis-marked components in the past. I now never fit any component without having checked it first.
__________________
Phil Optimist [n]: One who is not in possession of the full facts |
30th Nov 2017, 2:07 pm | #26 |
Dekatron
Join Date: Nov 2003
Location: Heckmondwike, West Yorkshire, UK.
Posts: 9,642
|
Re: Never assume anything!
|
30th Nov 2017, 5:11 pm | #27 |
Dekatron
Join Date: Apr 2012
Location: Worksop, Nottinghamshire, UK.
Posts: 5,554
|
Re: Never assume anything!
I can remember booking lots of overtime due to a miss marked reel of capacitors.
The pick and place machine was not fancy enough to test components before fitting them. It just carried on fitting the wrong part until the reel ran out. |