Display Fault on scanning but not on programming Signal R-532 Airband Rx - UK Vintage Radio Repair and Restoration Discussion Forum

M1BPT.UK · 13th Jun 2011, 5:35 pm

Hi Forum I have a problem with the LED Segments in the display on my Signal R-532 when it is in "Write" mode all the segments function as they should but switch to "Scan" or "Manual" modes and the 2 segments either side of the decimal point become intermittent. I have loaded frequencies to other address banks and the random fault seems to be the same I have a second one which I haven't really looked at yet as it was bought recently in a SK sale . Is this common with these sets ? Is their anyone who can give these a good service and alignment as my health is deteriorating best 73 Paul Stockport

13th Jun 2011, 5:35 pm	#1
M1BPT.UK Retired Dormant Member Join Date: Dec 2006 Location: Leicester, Leicestershire, UK. Posts: 5	Display Fault on scanning but not on programming Signal R-532 Airband Rx Hi Forum I have a problem with the LED Segments in the display on my Signal R-532 when it is in "Write" mode all the segments function as they should but switch to "Scan" or "Manual" modes and the 2 segments either side of the decimal point become intermittent. I have loaded frequencies to other address banks and the random fault seems to be the same I have a second one which I haven't really looked at yet as it was bought recently in a SK sale . Is this common with these sets ? Is their anyone who can give these a good service and alignment as my health is deteriorating best 73 Paul Stockport