UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

DoubleWound · 8th Dec 2019, 10:03 am

Following the restoration of my Taylor 45C and calibrating the grid volt pointer at 0V with a scope I sent three valves to sven swe.

He did a very professional Gm comparison on his two Taylor 45Cs and an AVO.

I'm delighted to say the results were very close and I now know that my Taylor is good to use.

I hope that sven swe will post his results with commentary.

I will be pleased to send the same valves to any other user of the Taylor 45C or for that matter a user of any type of valve tester.

Thanks Sven.

8th Dec 2019, 10:03 am	#18
DoubleWound Tetrode Join Date: Sep 2018 Location: East Grinstead, West Sussex, UK. Posts: 54	Re: Taylor 45C Grid Volt Calibration Following the restoration of my Taylor 45C and calibrating the grid volt pointer at 0V with a scope I sent three valves to sven swe. He did a very professional Gm comparison on his two Taylor 45Cs and an AVO. I'm delighted to say the results were very close and I now know that my Taylor is good to use. I hope that sven swe will post his results with commentary. I will be pleased to send the same valves to any other user of the Taylor 45C or for that matter a user of any type of valve tester. Thanks Sven.