Re: Telequipment D54 ?
Thanks for all of this extra information, I'm sure other people may find it beneficial also. Over here it looks like the 2N numbers are a lot easier to find. I will take a good look at all of this information. A good working dual FET substitute is good enough as far as I am concerned, just used as a hobby scope anyway.
I do have a good many old Tex scope transistor pull outs, but I am not sure if any of those will work for this input, and the time trying to figure it out could take a while. So does this 4 pin Mullard BFW 0265 that I need have a 2N number to look up and try to find?
I also see no reason why I can`t wire two 3 pin FET's together to make a dual FET to fit the four pin socket. Which 3 pin FET would be the question?
Thanks, Rodney.
|