Re: Cheap & Cheerful DIY UV PCB Exposure Unit
Hi Guys.... Hot off the press.... literally. I just tried this method using a "glossy magazine" page which had little on it...In most...it was ok....I did not apply the heat at the edges properly, thus some bits of track was missing.....I was not too happy with some of the edges which, on the artwork are straight, but when transferred to the copper were a bit un even. But as a "get out of jail free" method, for un important pcb's its great, and I will give it another go............well... as the iron is out.. I may as well do the domestic stuff.
__________________
Should get out more.
Regards
Wendy G8BZY
|