Re: Dansette Bermuda MK II ??
Thanks to all for their advice. I have attached a photo for confirmation of the sufflex capacitors that Lawrence suggested changing. I believe these are to be replaced with polystyrene caps butI have been unable to locate the 0.047uf only the 0.0022uf at 160V - can you suggest where I can obtain these.
My post 35 identified resistors that were not within tolerance and will replace unless it is not regarded as necessary. Will 2W be adequate?
The green welwyn resistor is not soldered at one end and I will correct this.
Should I replace the 100 ohm wire wound resistor even though the wire is burnt but the reading OK?
Any tips in replacing these components would be helpful as I have not soldered on a PCB board/limited space before but just on rails in a Hacker.
Martin
|