UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

MotorBikeLes · 27th Aug 2020, 10:12 pm

In post 22 you referred to the "HF stability" control. The HF stab should be either switched of, or minimum effect if input signals are lower frequency than say 5MHz. I don't have any info on this scope to hand, but that is my understanding from what you wrote. I am assuming you are not referring to a "Stability" control. Not sure I would expect there to be one on a scope of this era.
Les.

27th Aug 2020, 10:12 pm	#32
MotorBikeLes Nonode Join Date: Dec 2012 Location: Kirk Michael, Isle of Man Posts: 2,350	Re: Dynamco D7100 restoration In post 22 you referred to the "HF stability" control. The HF stab should be either switched of, or minimum effect if input signals are lower frequency than say 5MHz. I don't have any info on this scope to hand, but that is my understanding from what you wrote. I am assuming you are not referring to a "Stability" control. Not sure I would expect there to be one on a scope of this era. Les.