Re: Amateur radio interfacing
The installation on the bike. The panel mounting arrangement is very poor quality, so that is going to rattle about until I can improve it. The base unit is daft also, one hole for mounting hence the sub panel and Velcro mount.
PTT switch in the only place it can go. Only just within reach.
The loose wiring in the under seat area is a pending job. I need to build another interface there to select rider / pillion / both for the BC radio output. 'Indoors doesn't have any interest in being on the bike nowadays so low priority!
Last edited by Scimitar; 7th Jan 2019 at 3:54 pm.
|