View Single Post
Old 2nd Jan 2017, 12:53 pm   #31
Station X
Moderator
 
Station X's Avatar
 
Join Date: Jan 2003
Location: Ipswich, Suffolk, IP4, UK.
Posts: 21,286
Default Re: Tandberg Huldra 8 valve failure

Reading through this thread I find it astonishing that no attempt has been made to check the HT voltage or check for shorts across the HT supply, even though it has been suggested by several contributors. The OP has a meter which he used to check for continuity of the EM87's heater.

I reckon the OP will fit a new fuse and it'll blow again.
__________________
Graham. Forum Moderator

Reach for your meter before you reach for your soldering iron.
Station X is offline