UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - Help needed with

3pinplug · 14th Feb 2023, 10:54 pm

Hi Paula
I will check IC25 pins 3 & 13 in the morning and let you know the results. Its a double sided board so even if i desolder pin side the component side is also soldered so think it will be difficult to isolate the pins. If IC25 is suspect following these tests and the IC’s appear to be readily available i will change it.
Thanks again, your electronics knowledge is amazing and a credit to yourself and the forum.
Regards
Mark

14th Feb 2023, 10:54 pm	#100
3pinplug Pentode Join Date: Jun 2016 Location: Kent, UK. Posts: 190	Re: Help needed with - Racal Dana 9081 Hi Paula I will check IC25 pins 3 & 13 in the morning and let you know the results. Its a double sided board so even if i desolder pin side the component side is also soldered so think it will be difficult to isolate the pins. If IC25 is suspect following these tests and the IC’s appear to be readily available i will change it. Thanks again, your electronics knowledge is amazing and a credit to yourself and the forum. Regards Mark