Re: Help needed with - Racal Dana 9081
Hi Paula
Latest results as follows:-
All at 5v ampl/div
IC25 pins 6,11, I see a square wave, pins 2, 14 i see 12v on scope.
IC24 pins10,12 I see a square wave, pin 11 12v on scope, pin 13 is dead, nothing?
IC25 pin 5 pulsing seen
IC14 pin 7 pulsing seen
Found a dry joint on underside of board IC21 pin 15 but it is just an isolated pad so not sure it affect anything but will redo the joint.
Does the above mean IC24 needs replacing?
Regards
Mark
|