Re: 819 line standards convertor.
Hi Darryl,
I'm looking for a training concerning the rules of how to make stimuli for a work bench.
When I try to simulate with XILINX ISIM, my design stop after a short time.
I want to test my fifo design.
Below, it's the stimuli I need for my testbench.
first, I want reset for 100 ns.
Then, I want WR_EN go hight for continuous time=> in the same time, I need that DATA in's value change from 00 to FF.
4 uS after WR_EN is ON, I want that the RD_EN signal go hight.
Normally, if all the signal are ok, I should see in the RD_DATA, the value I put before.=> valu from 00 to FF.
Next time, I 'll send the screen shot of my bad simulation with wrong signal.
Thank you for your help.
Frédéric.
Last edited by pitbuell94; 18th Feb 2011 at 4:22 pm.
|