Re: The "Sussex" Homebrew Valve Tester.
Hi Guys
Attached is a photo of my modified Sussex after fitting Ed's transformer.
Note the addition of the heater voltage selector switch.
The button between the meters is the "Gas" test button mentioned in a previous post.
The printed area of the front panel is 297 x 60mm and can be printed out on standard paper. I used a 2mm clear perspex cover, a lot of firms on E Bay sell A4 size and will cut for no extra cost.
Now that the PCB is available, and Ed's transformer is imminent, it's time to go.
Regards
Mike
|