Re: The "Sussex" Homebrew Valve Tester.
Hi folks,
To those who have built themselves a Sussex VT1 using the new boards, I have a question that relates to the Voltage Selector switches and the way they are shown in post #1282 on page 65.
The resistors are shown mounted on the opposite side of the little board to the switch and seem a bit vulnerable to being bent over creating faults and shorts. I was thinking if the resistors were mounted on the same side of the board as the switch they would be better protected.
Any thoughts?
Incidentally, I bought my meters from 365-bestseller and had no difficulty. I contacted them to confirm the connections and they replied very quickly with the required information.
Cheers, Alf
Last edited by Alf Fisher; 1st Apr 2018 at 6:35 pm.
Reason: Post number added
|