View Single Post
Old 5th Dec 2020, 3:40 pm   #19
HBWOODY
Pentode
 
Join Date: Mar 2020
Location: Bodmin, Cornwall, UK.
Posts: 147
Default Re: VCM 163 problem while calibrating

Would I be correct in assuming that the oscillator board is ok if I am able to achieve the 15mV by adjusting RV1 on the oscillator board?
Thank you for pointing out my confusion over R14 and the thermistors.
Where does the signal which is adjusted to set the CAL position on the meter come from?
HBWOODY is offline   Reply With Quote