Now refit the sub chassis to the main deck and fit the 5 screws. Before tightening the two around the base of the pick up arm make sure that the lever arrowed
is on top of the screw thread. Note one of the screws around the spindle secures the tag which grounds the motor.
Fit the larger idler wheel making sure that it contacts the second largest step of the motor pulley (the 45 step) and tighten the two screws.
Refit the motor to the deck, fasten using the circlips.
Undo the cover to the switch, and resolder the yellow wire.
Refit the green wire to the terminal block.
Put a drop of oil on the turntable's idler wheel's spindle, refit the turntable idler wheel.
Clean the shaft of the overarm arm and lightly regrease, refit the balacing arm and fit the circlip to it under the deck.
Refit the pick up arm ensuring that it moves freely both vertically and laterally.
We are nearly there.