Here's one but without a dropper resistor:
https://www.vintage-radio.net/forum/...3&d=1224928154
The mains in from the on/off switch is the red wire, it connects to the motor feed and the 100 ohm surge limiter, the other end of that resistor is connected to pin 9 (a) of the rectifier, the white wire is the motor tap and is connected to pin 4 of the rectifier, pin 5 goes to feed the UCL82, pin 3 (k) is the yellow wire, it's connected to the reservoir capacitor and one side of the HT filter resistor (100 ohm on the transformer).
Lawrence.