UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Pilot Mariner · 9th Feb 2018, 7:35 pm

This is a bit of a long shot and a question for someone who has one of these. The mechanical programmer on this machine seems to have slipped a few teeth so that the dial setting does not correspond to the wash program. If someone has one of these can they tell me where the end of cycle position is on the rotating dial as its not obvious on the dial. In 21 years of faultless operation of this washer I never noticed where it is.

If I know where the off position is then I could merely rotate the dial to the required wash program with reference to the new off position.

9th Feb 2018, 7:35 pm	#1
Pilot Mariner Hexode Join Date: Jun 2003 Location: Burntwood, Staffordshire, UK or Kabaty in Warsaw Poland. Posts: 439	Zanussi Nexus washing machine This is a bit of a long shot and a question for someone who has one of these. The mechanical programmer on this machine seems to have slipped a few teeth so that the dial setting does not correspond to the wash program. If someone has one of these can they tell me where the end of cycle position is on the rotating dial as its not obvious on the dial. In 21 years of faultless operation of this washer I never noticed where it is. If I know where the off position is then I could merely rotate the dial to the required wash program with reference to the new off position.