UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Station X · 16th Feb 2006, 10:09 pm

The Wave Change Switch of the DAC90A I'm currently working on has no indexing or endstops ie it moves freely, but does not click into place on either LW or MW.

On the inboard end of the shaft are two rather bent brass tabs with holes in them. Am I right in thinking that a ball bearing fits in the hole in one tab and the other tab applies spring pressure to the ball?

16th Feb 2006, 10:09 pm	#1
Station X Moderator Join Date: Jan 2003 Location: Ipswich, Suffolk, IP4, UK. Posts: 21,289	DAC90A Wavechange Switch indexing. The Wave Change Switch of the DAC90A I'm currently working on has no indexing or endstops ie it moves freely, but does not click into place on either LW or MW. On the inboard end of the shaft are two rather bent brass tabs with holes in them. Am I right in thinking that a ball bearing fits in the hole in one tab and the other tab applies spring pressure to the ball? __________________ Graham. Forum Moderator Reach for your meter before you reach for your soldering iron.