Re: Taylor 45a Components
Here is what my Taylor 45A has on the tag board, the values I measured for the wire-wound resistors are shown in brackets together with the nearest standard E24 value (can anyone verify the last two wire-wound resistors as the values differ a bit from the 45B parts list & the 45A manual has no parts list).
Component values from left to right:
wire-wound 2K (measured 1.95k ohm)
(brown,black,orange) 10K
wire-wound 560 ohm (measured 544 ohm)
(brown,brown,brown) 110 ohm
capacitor 0,25 µf
(brown,blue,red) 1K6
(brown,black,yellow) 100K
(red,violet,orange) 27K
(red,red,brown) 220 ohm
Component values from top right to bottom right:
wire-wound 24 ohm (measured 24.4 ohms)
(blue,grey,brown) 680 ohm (uses dog-bone resistor colour code)
(red,red,red) 2K2
wire-wound 33 ohm (measured 31.9 ohms)
David
Last edited by factory; 9th Jun 2019 at 6:52 pm.
Reason: Correction
|