Re: GEC 1000 phone not working properly?
I've had to dig mine out now...
The pic shows the Mic, Inset No: 13 with spring-ring around the 'flying saucer' and you will see the bent-back protrusion that engages with the notch in the side of the mouthpiece cup. The connections are as shown, but the mic pin that connects to the rear of the inset is one I cut down from a scrap 'Handset 164', and not the original. That may be at my work and I'll look for it next week.
The handset is ( it think) urea formaldehyde, not Bakelite as I stated earlier, but the profile of the 'Handset No:1' is quite different to the 'Handset No:3' and the section that is held is more like that of a 'Handset 164'. Note the ETL (Ericsson Telephones Limited) logo moulded on.
__________________
Regds,
Russell W. B.
G4YLI.
|