This is very confusing ..
So
I have the EMP10 setup as follows..
Kernal bin selected
As the photo suggests the correct personality module for the motorola device is 1A ..
No programming possible..
(basically wrong module even though software says use 1A)
another photo shows the error response.
I flip the module to use 1B
I no longer receive an error message ..and it looks like I can program.
Not so another message appears mere seconds after starting the process, which arent clear in photo
a verify error.
these read :-Buffer Address 00000000 Buffer Data 0F
Device Adress 00000000 Device Data FF
Which would make sense as the chip is blank
This is the total opposite of what should be fitted according to the software.
1A recommended (doesnt work at all)
1B not recommended ( sort of allows to start but doesn't run)
So in other words ..software gets it totally wrong ??
I may well send you a chip and the Kernal.BIN if only to shed some light on this mystery.
For now at least I'll keep trying to resolve this ..as I feel I've wasted another load of dosh ..and only got a duplicate of what I already had.
I really think I should be ignoring the software ..and Use 1B ..but the software Algorythm is incompatible ..even though it says it should be possible ?