Taylor 65B Sig Generator: Dodgy Waveform
The output waveform from my Taylor 65B is not what I would expect.
Instead of a symmetrical amplitude modulated wave, only the bottom half of the wave is modulated. The top half is flat.
The 400Hz from V2 is clean.
I have replaced the usual caps and a few out of tolerance resistors but the output is still dodgy. Can anybody shine a light on why the output would be asymmetric?
Thanks.
Last edited by HowardB; 28th Nov 2021 at 7:53 pm.
Reason: more info added
|