[Phantomrose1999]

Thanks for the reply..

I have found the following caps and RC networks, though i would share it here first before i order them.

1) Kemet 5% 1uF plasic Can cap ( i think this will fit on the other side of the motor, just above the relays)

2) Kemet 5% 3.5uF Metal Can cap. This will go where the original went

3) Kemet 0.22uF 100Ohm RC networks. Will replace all 4, BUT all 4x have had their wires cut in my unit.. ??

4) There are a large 0.1uF and 0.5uF black caps that are split open, will replace these.

Not thouching anything else..

See data sheets if any body else wants to try these AFTER i test it..ha