Re: Gemini 80-Bus System
Yes you can trace between buses. To trace you need to place the boards
to be traced on a seaperate bus and then use intbus to create a bridge
between the two buses
For example to trace the scsi activity of the scsi interace use the following
in your config file
#select future boards to be on the trace bus
bus trace
#Create your scsi/floppy boards here (port range 0e0..0e7)
board.....
board....
#select the z80 io bus
bus io
#now create a bridge from the io bus to the trace bus (0e0..0e7) split
#between tracing/non tracing as required
#
#following ports bridged but not traced
board 0e0 intbus 0xe0 5 rw trace
#following ports traced
board 0e5 intbus 0xe5 3 rwt trace
That should do the magic...
|