Re: Circuit Symbol Sizes and Proportions?
Hi!
I've re-drawn and re-proportioned the resistor and capacitor symbols and made some genuine Newnes "true-earths", - me thinks they're as good as I can get them!
Chris Williams
PS!
I can't promise it'll be a quick job as it will take some time to write but I'll explain how to draught the symbols in due course!
You will require, if you're not using Abacom's SPlan 7.0, EDA/Circuit Schematic Software that can draw on a 0.1 mm/0.2mm grid, or, if your EDA software's schematic editor is scaled in "mils" (thousands of an inch), 5 mil and 10 mils.
I'll deal with the circuit and valve-symbols, then I'll go onto valve-bases!
__________________
It's an enigma, that's what it is! This thing's not fixed because it doesn't want to be fixed!
Last edited by Chris55000; 14th Jun 2018 at 12:13 am.
|