View Single Post
Old 29th Mar 2008, 6:39 pm   #4
igranic
Rest in Peace
 
igranic's Avatar
 
Join Date: Jan 2005
Location: North Bedfordshire, UK.
Posts: 395
Default Re: Making Replacement Knob Brights.

Robert,

Thank you for your kind comments.

This method could be used for most knob brights formed from sheet brass or aluminum unless they have a swaged-over or roll-formed edge. These, and other more complex types could be probably be turned from solid bar using a form tool or CNC control.

As I do not possess a TR82/MB60, and can't readily find any really good close-up pictures of their dial brights, it is difficult for me to express an opinion. If you could post pictures of the front and rear of a typical bright I will try to be more specific.

Edward
igranic is offline