Re: Wireless Set 19 repairs question.
Hi David
If the transformer has a center tapped winding of 12-0-12 configuration the center should be to ground and the 2 12v connections to the bridge ac terminals. The bridge +VE output will be approx +12v off load relative to ground. Ignore the bridge -ve output which will be about -12v and leave floating. I understand from your earlier posts that only 2 diodes were present previously which would suggest that this is the rectifier configuration you have which is a standard bi-phase rectifier circuit. The use of the bridge usually eases installation and allows bolting to the chassis as a heatsink.
The negative arms are redundant unless you need a -ve supply.
Good luck!
Orakle42
|