Re: Simple method to mark calibration and functions externally on a case?
Hello everyone,
I'm just stopping by briefly to say that I'm delighted with the response to my query.
I'd like to thank you all individually but I'm tied-up for much of the day, so I'll just note that there's lots for me to study, absorb and evaluate.
It's clear that a level of patience and some trial-and-error and 'drafts' are going to be involved. I can be patient, and I enjoy learning new skills, so I'll give this learning curve the space it needs and see what I can come up with. Fortunately for me, I do already own a Brother label printer and am impressed by the choice of typefaces and how the lettering stands out, especially when set in bold, against the transparent backing tape.
I will also attempt to make markers for dial calibration, using some of your suggestions - although this seems tricky compared to my current skill and experience level with the relevant software.
I hope to come back to you with some feedback sooner or later.
This is a wonderful thread and I hope people continue to share their ideas.
Thank you again, and I'lll check back in when I can.
Cheers!
__________________
Al
|