View Single Post
Old 22nd May 2019, 4:47 am   #7
Sufferinghusban
Triode
 
Join Date: Apr 2019
Location: Nowra, New South Wales, Australia
Posts: 10
Default

Thanks for all the info guys. This is a FT-7 not the Bravo. In all honesty I am flying blind with this. I can't find a circuit diagram for the board. There are ones about for the Bravo but not the plain Jane 7 that I can locate. All I know is that I have 12V permanantly one one of the lines, and the line opposite it gets close to a 0.7v when I key the mic on CW. I have been trying to find where I can adjust the RF output as I thought it may have been knocked down as well, but no such luck, nothing about that I can find. This radio has been modded at some stage to get it onto another band, probably 11m. If that was the case they probably had the RF turned up all the way, as some people did back in the day Hmmmmm.. Hmmmm..

I more than likely have the E B C confused as I can't tell what is what by looking at it. There is so much solder I can't find the tab with the corner cut without pulling them. With no diagram for it as well it makes it difficult.
Sufferinghusban is offline