View Single Post
Old 20th Dec 2016, 2:07 pm   #23
Radio Tech
Nonode
 
Radio Tech's Avatar
 
Join Date: Dec 2012
Location: Bocking, near Braintree, Essex, UK.
Posts: 2,068
Default Re: Tandberg Huldra 8 valve failure

Hi Clive,

I think I would tackle the set this way, start by removing the fuses, check to see if you have all the appropriate voltages between ground and at that point, after that, if you take your time, work through the circuit in a methodical manner, and if necessary unsolder components or leads at one end and check. It may seem a little daunting at first but I am sure you will get there, it also may be worth checking those electrolytic capacitors.

Best wishes and seasons greetings

Ken
Radio Tech is offline