UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Argus25 · 2nd Dec 2019, 11:08 pm

......I don't do too many double sided boards but on one occasion I applied the film to one side, then drilled two small registration holes to position the top film as best possible. Also , looking at the Jaycar site now this film isn't what you would call cheap, I bought a lot of it some years ago and have been working my way though it, it must have been around for many years. I have also read that some people have tried to apply it with a laminator machine, but I doubt that would be as good as a clothing iron. Also I have not used it as much for very fine pitch IC's.

2nd Dec 2019, 11:08 pm	#7
Argus25 No Longer a Member Join Date: Oct 2016 Location: Maroochydore, Queensland, Australia. Posts: 2,679	Re: PCB Artwork transfer ......I don't do too many double sided boards but on one occasion I applied the film to one side, then drilled two small registration holes to position the top film as best possible. Also , looking at the Jaycar site now this film isn't what you would call cheap, I bought a lot of it some years ago and have been working my way though it, it must have been around for many years. I have also read that some people have tried to apply it with a laminator machine, but I doubt that would be as good as a clothing iron. Also I have not used it as much for very fine pitch IC's. Last edited by Argus25; 2nd Dec 2019 at 11:15 pm.