Re: Standard Beam Approach - Rebuild update
Hi All
All the original components I'll be using have now be cleaned. All solder joints re-soldered. New components have been 'made'. So now I am ready to start the rebuild!
The following pics show the parts. I have reused the waxy cap ident sleeves to maintain more originality but I believe that they would have been white at first, rather than yellow.
Happily the main connector is NOS and really in good condition - sadly I don't have the mating part!
Since I am reverting a receiver that had been converted to the 'C' variant back to it's original 'A' variant there are a few component changes. One notable one is a 4 x 2uF capacitor which had been replaced by a smaller one with only 2 x 2uF. I've gutted that one, drilled the base to take 4 off HV feed thrus fitted 4 x relatively tiny electrolytics and sealed the end that originally had the connection pins. Resprayed and re-annotated.
|